Tv problem

diana96, Sep 11, 6:42am
can anybody tell me why i can only get channel 1 and 2 onanaloguetv. when i retune to digital 1 and 2 are just not available. seemed to happen after the storm last week. thanks , its a panasonic flatscreen with built in freeview.

spyware, Sep 11, 6:52am
Antenna issue. TV1 and TV2analog are on VHF channels 3 (61 to 68 MHz) and 8 (202 to 209 MHz) respectively (assuming Sugarloaf). Digital, DVB-T H.264, versions of TV1 and TV2 are on UHF channel 34 (574 to 582 MHz). A completely different part of the spectrum.

You need a nice antenna looking like

http://www.freeviewshop.co.nz/element-aerial-freeview-p-457.html


spyware, Sep 11, 6:52am
Antenna issue. TV1 and TV2analog are on VHF channels 3 (61 to 68 MHz) and 8 (202 to 209 MHz) respectively (assuming Sugarloaf). Digital, DVB-T H.264, versions of TV1 and TV2 are on UHF channel 34 (574 to 582 MHz). A completely different part of the spectrum.

You need a nice antenna looking like

http://www.freeviewshop.co.nz/element-aerial-freeview-p-457.html

Question: Do you get U and TV1+1 on digital!

diana96, Sep 11, 6:57am
yes we do. only 1 and 2 on analogue.

diana96, Sep 11, 6:57am
yes we do. only 1 and 2 need analogue. thanks for the info.

spyware, Sep 11, 7:14am
So you go into Setup/Channels/Autoscan!

diana96, Sep 11, 7:20am
yes we do . when we watch the channels being located and loaded 1 and 2 arent there. when we switch to 1 it says invalid channel. and snow

spyware, Sep 11, 9:19am
Does TV have ability to display signal strength and signal quality (looks at bit error rate) for each channel, 32 (Mediaworks), 34 (TVNZ) and 36 (Kordia) are the 3 DVB-T muxes.

diana96, Sep 11, 6:36pm
yes it does give a rating for each channel that it scans in when using auto tune but 1 and 2 dont feature. im going to have to get a tv guy round i supose. it was fine but something has happened. al the other channels get excellent.

Share this thread

Buy me a coffee :)Buy me a coffee :)