Problems configuring HP Jet direct box wirelessly

christin, Aug 9, 3:05am
i have a wireless jet direct box. I can configure it as far as the software goes. ie run the setup, the software detects the box on the wired network.

Select you want it to run wirelessly, set the network and password, put in ip address and it then says it will configure it, and to remove the network cable etc.

when I do this, the wireless network light is flashing, not solid, like its trying to connect unsuccessfully to the network. When I print out the config page it isn't on the wireless network.

any ideas why? I did have it going before as in a solid light, but this was dhcp and I wanted a fixed ip, so reset and started again. now I cant get either working!


Share this thread

Buy me a coffee :)Buy me a coffee :)